Greetings everyone and welcome to my website Vettaville. This website is dedicated to providing unique information about some of Line 6's modern guitar/amp technology...particularly the Vetta as well the Variax. Also visit the Netherlands Vettaville and join us for equipment discussions at Andy Z's Institute of Noise Forums.

email: nathanshane@vettaville.com

 

 

Continued

Now that you have your head out of your cab (couldn’t help myself), put it on an area where you have plenty of room to work. Now use the allen wrench to remove the screws around the top of the back panel

 

After you have taken out the screws and removed the black trim piece, gently and slowly raise/rotate the faceplate from the rear towards the front. You will notice one data cable, and one signal cable that limit continued movement. Disconnect these 2 cables from the faceplate.

 

Now lay the faceplate down carefully trying not to scratch it. I used the box that the VDI was shipped in to rest the faceplate on, this was perfect height. Simply place the box behind the front part of the head and lay the upside down faceplate on it. This should allow some give on the cables that are still connected.

 
<- Previous Page Next Page ->